Vaddio DocCAM 20 HDBT OneLINK Bridge System - Manual (Page 58)

Communication and Power Commands
These commands are available for managing power and sequences of actions:
n network settings get
n link power
network settings get
Returns the current network settings for MAC address, IP address, subnet mask, and gateway.
Synopsis network settings get
Example > network settings get
Name eth0:WAN
MAC Address 00:1E:C0:F6:CA:7B
IP Address 192.168.1.67
Netmask 255.255.255.0
VLAN Disabled
Gateway 192.168.1.254
OK
>
link power
Sets the camera's power connection on or off.
Note
The OneLINK device does not provide camera control. To set the camera to standby instead of powering
it off, use the camera's remote or other camera control interface to issue a standby command directly to
the camera.
Synopsis link power { on | off }
Options off Powers off the camera connection. Camera
power remains off until the OneLINK device
receives a
link power on command or a
reboot.
on Powers on the camera connection.
Examples > link power off
OK
>
Powers off the camera connection.
Complete Manual for the OneLINK Bridge AV Interface
54