HP Data Explorer 4 Series - Manual (Page 161)

Peak Labeling
Data Explorer ™ Software User’s Guide 3-63
3
6. To manually enter label settings, click .
The User Label Entry dialog box is displayed
(Figure 3-24).
Figure 3-24 User Label Entry Dialog Box (Spectrum)
7. Set the following parameters:
Spectrum Parameter Description/Specifies
Label Text of the label to display.
Peak Mass (if Label Type selected
is Mass) Mass of the peak to which the label applies.
Mass Difference (if Label Type
selected is Difference) Difference in mass that must exist between
peaks to apply user labels.
Mass Tolerance Mass tolerance that the peak must occur
within to apply user labels.
NOTE: If a peak meets the criteria for more
than one user label, multiple user labels are
applied to the peak and are separated by
commas.
Charge State Charge state that the peak must have in
order to apply user labels.