LG C Series - Manual (Page 37)

Chapter 5. Programming keypad
z Parameter initialize
How to initialize parameters of all four groups in H93
Function
group 2
1 -. In H0, press the Prog/Ent ( z) key once.
2
-. Code number of H0 is displayed.
-. Increase the value to 3 by pressing the Up (
S) key.
3 -. In 3, press the Left (
W) key once to move the cursor to the left.
4
-. 03 is displayed. 0 in 03 is active.
-. Increase the value to 9 by pressing the Up (
S) key.
5
-. 93 is set.
-. Press the Prog/Ent (
z) key once.
6
-. The parameter number is displayed.
-. Press the Prog/Ent (
z) key once.
7
-. Present setting is 0.
-. Press the Up (
S) key once to set to 1 to activate parameter initialize.
8 -. Press the Prog/Ent ( z) key once.
9
-. Return to the parameter number after blinking. Parameter initialize has been
complete.
-. Press the either Left (
W) or Right (X) key.
10 -. Return to H0.
37