RuggedCom RuggedRouter RX1100 - Manual (Page 103)

12. Configuring PPP And the Embedded Modem
Revision 1.14.3 103 RX1000/RX1100™
The RADIUS Authentication field will cause incoming PPP connections to be authenticated against
the RADIUS servers configured in the Maintenance menu, RADIUS Authentication sub-menu.
Note
The Dial-in Console and PPP Server can be enabled at the same time. The router will automatically
detect whether an incoming call is PPP or console only. If PPP Client mode is active, it will try to
maintain the PPP link at all times, and hence block incoming calls most of the time. Enabling the
PPP Client at the same time as the Dial-in Console and/or PPP Server is not recommended.
Rings before answer controls how many times to let the modem ring before answering a call, if either
of Dial-in console or PPP Server is enabled.
Additional Modem AT Init Codes allows extra AT command codes to be entered if required. Note
that care must be taken to ensure the correctness of any AT command codes entered here, as the
router does not verify them. A selection of supported AT codes for the Internal modem follow. For
equivalent codes for an external modem, please refer to the documentation for the external modem
used.
Blind dial
X0 - Ignore dialtone/busy signal. Blind dial.
X4 - Monitor and report dialtone/busy signal. (default)
Guard tone control
&G0 - Disable guard tone. (default)
&G1 - Enable guard tone at 550Hz.
&G2 - Enable goard tone at 1800Hz.
Pulse dialing control
&P0 - Make/break ratio of 39/61 at 10 pulses/second. (default)
&P1 - Make/break ratio of 33/67 at 10 pulses/second.
&P2 - Make/break ratio of 39/61 at 20 pulses/second.
&P3 - Make/break ratio of 33/67 at 20 pulses/second.
Compression control
%C0 - Disable data compression negotiation.
%C1 - Enable MNP5 compression negotiation.
%C2 - Enable V.42bis compression negotiation.