RuggedCom RuggedRouter RX1100 - Manual (Page 267)

31. Configuring The Telnet Server
Revision 1.14.3 267 RX1000/RX1100™
any configured IP address. If "All addresses" is not selected, then the telnet server will only respond
from highlighted addresses in the list below.
The Save button will commit the configuration change. If the telnet server is not running, the
configuration will be saved but will not start the server. If the telnet server is running, the configuration
will take effect immediately.
The Start Telnet Server button allows you to start telnet server. This is the same as starting the telnet
server from the Bootup and Shutdown menu.
Note that if the telnet server is running, the Stop Telnet Server button will be shown instead of
the Start Telnet Server button. Note also that if the telnet server is stopped, currently active telnet
connections will not be terminated.