RuggedCom RuggedRouter RX1100 - Manual (Page 62)

6. Configuring Ethernet Interfaces
Revision 1.14.3 62 RX1000/RX1100™
6.2.1. Ethernet Interfaces
Figure 6.2. Current and Boot Time Ethernet Configuration
This menu allows you to display and configure the Ethernet interfaces in the router.
The Current Configuration table allows you to try out changes on the existing interfaces before
making permanent changes. Any changes made take effect immediately, but will not be present after
the next boot. The entries in this table can also be used to temporarily disable or re-enable an interface.
The Boot Time Configuration table router allows you make changes to the "permanent" configuration
of any interface.
The Network Configuration menu Apply Configuration button applies permanent changes and
restart Ethernet networking. If only temporary changes have been made, the permanent configuration
will be re-applied.
In either table, edit the desired interface by clicking on its link under the Name column.
6.2.2. Editing Currently Active Interfaces
Figure 6.3. Editing a Network Interface