RuggedCom RuggedRouter RX1100 - Manual (Page 33)

1. Setting Up And Administering The Router
Revision 1.14.3 33 RX1000/RX1100™
Figure 1.14. LED Status Panel
The LEDs are organized into three primary groups; the port group, GPS/PPP group and the Alarm/
Power Supply group. The display possibilities are as follows:
LED Name Description
LED 1-4 Green: link activity on Ethernet port 1-4
LED 5-8 Green: link detected on Ethernet port 1-4
Red: link failure on Ethernet port 1-4
LED 9-12 Green: link activity on WAN port 1-4
LED 13-16 Green: link detected on WAN port 1-4
Red: link failure on WAN port 1-4
LED 17-20 Green: link activity on WAN port 5-8
LED 21-24 Green: link detected on WAN port 5-8
Red: link failure on WAN port 5-8
PPP-DATA Green: link activity on PPP Modem port
PPP-LINK green: link detected on PPP Modem port
GPS-LOCK Green: The PTP card has acquired a GPS satellite lock
ALARM Red: A Major Alarm exists
POWER 1 Green: Power Supply 1 is working properly
Red: failure detected in Power Supply 1
POWER 2 Green: Power Supply 2 is working properly
Red: failure detected in Power Supply 2
Table 1.1. Meaning of LEDs
The software will cause the ALARM LED to become active for various reasons. Any condition that
causes the ALARM LED to become active will activate the critical fail relay. The Web interface displays
the alarms.
Pressing the pushbutton for more than five seconds will reboot the router.
1.6. Obtaining Chassis Information
The chassis displays the hardware inventory at boot time. This information is captured in the /var/
log/messages file after boot. The Web Management interface home page displays the chassis serial
number.