RuggedCom RuggedRouter RX1100 - Manual (Page 80)

8. Configuring Frame Relay/PPP And T3/E3
Revision 1.14.3 80 RX1000/RX1100™
8.2. T3/E3 Configuration
Figure 8.1. T3/E3 Trunks And Interfaces
This menu allows you to display and configure T3/E3 Trunks as well as display the routes and status
of the network interfaces.
8.2.1. T3/E3 Trunk Interfaces
Figure 8.2. T3/E3 Network Interface Initial Configuration
This menu allows you to display and configure T3/E3 Trunk parameters. A table is presented for each
interface.
Interface numbers are as described by the "WAN" labels as shown in the home page chassis diagram.
The status of each trunk's physical and logical interface is shown. The menu presents connection
status, but note that it does not update in real time. Click on the Refresh this page link to update
the status display.
Each T3/E3 trunk may be configured as a Frame Relay link with one or more DLCIs, or as a single PPP
link. Select Assign a New Frame Relay logical interface or Assign a new PPP logical interface,
respectively.
The contents of the menu will change after the creation of logical interfaces, providing links to logical
interface configuration and statistics and overall trunk statistics, as seen below: