RuggedCom RuggedRouter RX1100 - Manual (Page 223)

24. Configuring Serial Protocols
Revision 1.14.3 223 RX1000/RX1100™
Note that the Serial Protocols server is disabled by default and may be enabled via the Bootup And
Shutdown menu, under the System folder of the main Webmin menu.
The Assign Protocols menu assigns a serial protocol to one of your serial ports.
The Port Settings menu configures the serial port and its electrical protocol.
If any of your serial ports are configured as RawSocket protocol, this menu will configure them.
The Serial Protocols Statistics menu will show you the status and statistics for any established
sessions.
The Line Trace menu will provide a line activity trace for the serial ports.
24.2.2. Assign Protocols Menu
Figure 24.3. Assign Protocols Menu
This menu associates a protocol with a serial port. Unused ports should be left associated with "none".
Changing an association will immediately close the calls of the old protocol.
24.2.3. Port Settings Menu
Figure 24.4. Port Settings Menu
This menu configures the serial settings and electrical protocol associated with a serial port. Changes
are made immediately.