RuggedCom RuggedRouter RX1100 - Manual (Page 140)

15. Traffic Control
Revision 1.14.3 140 RX1000/RX1100™
Add a new traffic class by selecting the Add a new traffic classification class link or by clicking on
the add-above or add-below images in the Add column.
Clicking on a link in the Interface column will allow you to edit or delete a traffic classification class
as shown below. The Manually Edit File button also allows you to make direct changes to the TC
Classes configuration file.
Figure 15.4. Edit TC Classes
The Interface field specifies which network interface this TC Class applies to.
The Mark to match field specifies what mark value this TC Class will match. The mark may be in
the range 1..255 in decimal or hex.
The Minimum rate field specifies the minimum bandwidth allocated to this class.
The Maximum rate field specifies the maximum bandwidth allocated to this class.
Bandwidth is specified in megabytes per second (mbps), megabits per second (mbit), kilobytes per
second (kbps), kilobits per second (kbit), or bytes per second (bps). Alternately it can be specified as
a fraction of the full port speed defined in the TC Interfaces menu.
The Priority field specifies the priority with which this class is serviced. Please note that lower value
priority classes will be serviced first (and hence with lower latency). The lower priority classes are
also the first to be allocated any leftover bandwidth after all classes have been provided with their
minimum bandwidth. Priority may be in the range 0..255.
The default option field sets the current class as the default class for the interface. Please note that
you must define exactly one default class per interface.
The tos-minimize-delay option field specifies that a packet with the minimized delay ToS (ToS bit
3 set) belongs to this class.
The tos-maximize-throughput option field specifies that a packet with the maximize throughput ToS
(ToS bit set) belongs to this class.
The tos-maximuze-reliability option field specifies that a packet with the maximize reliability ToS
(ToS bit 5 set) belongs to this class.