RuggedCom RuggedRouter RX1100 - Manual (Page 224)

24. Configuring Serial Protocols
Revision 1.14.3 224 RX1000/RX1100™
24.2.4. RawSocket Menu
Figure 24.5. Raw Socket Menu
This menu configures the Raw Socket settings for each port. Changes are made immediately.
The Pack Char field configures the numeric value of the ASCII character which will force forwarding of
accumulated data to the network. The Pack Char must be between 0 and 255 inclusive or the value off.
If configured off, accumulated data will be forwarded based upon the packetization timeout parameter.
The Pack Timer field configures the delay from the last received character until when data is
forwarded. The Pack Timer must be between 5 and 1000 milliseconds inclusive.
The Turnaround timer field controls the amount of delay (if any) to insert between the transmissions
of individual messages out the serial port. The Pack Timer must be between 1 and 1000 milliseconds
inclusive, of off.
The Call Dir field configures whether to accept an incoming connection, place an outgoing connection
or do both.
The Max Conns field configures the maximum number of incoming connections to permit when the
call direction is incoming.
The Remote IP field configures the address used when placing an outgoing connection.
The Remote Port field selects the TCP destination port used in outgoing connections.
The Local Port field selects the local TCP port to use to accept incoming connections.
24.2.5. TcpModBus Menu
This menu configures the TcpModbus settings for each port. Changes are made immediately.
Figure 24.6. TcpModbus Menu