RuggedCom RuggedRouter RX1100 - Manual (Page 226)

24. Configuring Serial Protocols
Revision 1.14.3 226 RX1000/RX1100™
The Max Conns field configures the maximum number of incoming DNP connections.
The Loc Port field configures the TCP/UDP port number on which DNP protocol listens. DNP devices
normally use port 20000.
The Device Address field configures a DNP device address, whether local or remote. The address
may be that of a DNP device connected to a local serial port or one available via the serial port of a
remote IP host. The address may be in the range 1 to 65520. Note that both local and remote serial
ports must be properly configured.
The Rem IP field configures the IP address of the remote host that provides a connection to the DNP
device with the configured address.
Figure 24.8. DNP Device Table Settings
The Port field configures the serial port to which the DNP device is attached. If the entry is for a
remote DNP device, i.e. the DNP device is attached to the serial port of remote IP host, the value
of this parameter is 'Unknown'.
Device Address Table
This table displays all currently known active DNP devices.