RuggedCom RuggedRouter RX1100 - Manual (Page 166)

17. Configuring Dynamic Routing
Revision 1.14.3 166 RX1000/RX1100™
17.2.1. Enable Protocols
Figure 17.3. Dynamic Protocol Enable Menu
This menu enables RIP and OSPF for dynamic routing.
17.2.2. Core
Figure 17.4. Core Menu
The Core routing daemon handles communications between the kernel of the router and the other
dynamic routing protocols. The core handles link detection, static route monitoring, and routes for
directly connected interfaces on the router. It also manages adding routes to the kernel routing table
based on the routes discovered by other dynamic routing protocols. Core is always enabled whenever
dynamic routing is enabled as it is required by all other dynamic routing protocols.
17.2.2.1. Core Global Parameters
Figure 17.5. Core Global Parameters
The Enable Password field sets the password to be used for the enable command of core. This is
used by the telnet interface of core to control access to the configuration.
The Telnet Password field sets the password to be used for telnet access to core. This is used as
the login password of core when locally telnetting to port 2601 of the router.