RuggedCom RuggedRouter RX1100 - Manual (Page 84)

8. Configuring Frame Relay/PPP And T3/E3
Revision 1.14.3 84 RX1000/RX1100™
Link, Frame Relay And PPP Interface Statistics are as described in detail in the T1/E1 Statistics
section of the chapter on Chapter 7, Configuring Frame Relay/PPP And T1/E1 . The differences are
that the T3/E3 link reports only only AIS, LOS, OOF and YEL alarms.
8.2.4. Current Routes & Interface Table
The table provided by this command is the same one as described in the Networking menu, Network
Utilities sub-menu. It is also provided in the T3/E3 configuration menu as a convenience.
8.2.5. Upgrading Software
In some installations, the only access to a RugegdRouter at a remote site may be via a a T3 or E3
connection. Usually a ROX system software upgrade will stop the system, perform the upgrade, and
then restart it. If the T3/E3 port were to be upgraded in this way, the upgrade would fail as the T3/
E3 link would be taken down. Instead, T3/E3 software upgrades modify only the software on the disk.
You must schedule a reboot in order to run the new version of T3 software.