RuggedCom RuggedRouter RX1100 - Manual (Page 21)

About this User Guide
Revision 1.14.3 21 RX1000/RX1100™
Basic Web Based Configuration
11. Change the router password from the System menu, Change Password sub-menu.
12. If you are using the web management interface you may wish to restrict the allowed users to a
specific subnet. This can be done in the Webmin menu, Webmin Configuration, IP Access
Control sub-menu.
13. If you are planning to SSH in to the router you may wish to restrict the allowed users to a
specific subnet. This can be done in the Servers menu, SSH Server, Networking sub-menu.
14. The router's local hostname may configured in the System Menu, System Hostname sub-
menu.
15. The router may be configured to log to a remote server by the Maintenance menu, System
Logs sub-menu. See the chapter “Maintaining The Router” for more details.
16. The router's DNS settings may configured in the DNS Clients sub-menu. You may also specify
the IP addresses of frequently used hosts. See the chapter “Configuring Networking” for more
details.
Physical Interface Related
17. Ethernet port parameters may be changed in the Networking menu, Ethernet sub-menu.
The Ethernet Interfaces sub-menu will configure the IP address, subnet mask, gateway
address, proxy arping and media type of each interface. See the chapter “Configuring Ethernet
Interfaces” for more details.
18. If your router is equipped with T1/E1 WAN interfaces, the Networking menu, T1/E1 sub-
menu will allow you to configure them with Frame Relay or PPP connections. See the chapter
“Configuring Frame Relay/PPP And T1/E1” for more details.
19. If your router is equipped with T3 WAN interfaces, the Networking menu, T3 sub-menu
will allow you to configure them with Frame Relay or PPP connections. See the chapter
“Configuring Frame Relay/PPP And T3” for more details.
20. If your router is equipped with DDS interfaces, the Networking menu, DDS sub-menu
will allow you to configure them with Frame Relay or PPP connections. See the chapter
“Configuring Frame Relay/PPP And DDS” for more details.
21. If your router is equipped with ADSL interfaces, the Networking menu, ADSL sub-menu will
allow you to configure them. See the chapter “Configuring PPPoE On ADSL” for more details.
If you wish to use PPPOE with an external ADSL modem, the Networking menu, Ethernet
sub-menu will configure it.
22. If your router is equipped with an embedded modem, the Networking menu, Modem sub-
menu will allow you to configure it with PPP or incoming console connections. See the chapter
“Configuring PPP And Modem” for more details.
23. If your router is equipped with Serial Interfaces, the Servers menu, Serial Protocols sub-
menu will allow you to configure them with an operating protocol. See the chapter “Configuring
Serial Protocols” for more details.
24. If your router is equipped with a Precision Time Protocol Card, the Servers menu, IRIGB sub-
menu will allow you to enable and configure its output ports. See the chapter “Configuring
IRIGB” for more details.