RuggedCom RuggedRouter RX1100 - Manual (Page 301)

34. Maintaining The Router
Revision 1.14.3 301 RX1000/RX1100™
34.6.3. Network Addressing Configuration
For reference, the set of currently configured and active IP addresses is listed near the top of the page.
Figure 34.25. Network Addressing Configuration Menu, Client Address
The Client address (Source IP) field specifies the address from which snmpd will send notifications.
If the field is blank, the default behaviour will be to transmit the notification from the IP address of
the interface from which the message leaves the router. Snmpd will return to this behavour if the
configured address is not available when it starts.
Figure 34.26. Network Addressing Configuration Menu, Addresses to listen on
The table of Addresses to listen on includes the list of currently configured and active IP addresses,
and whether the address is currently listened on. The New field allows for the addition of other IP
addresses.
Snmpd will use these addresses providing they are active at the time it starts. By default, snmpd
listens on all interfaces.
34.6.4. Access Control
Figure 34.27. Access Control Menu, SNMP V1 and V2c