Single network with static ip assignment, Single network with option82 clients on one switch – RuggedCom RuggedRouter RX1100 User Manual
Page 246
27. Configuring The DHCP server
Revision 1.14.3
246
RX1000/RX1100™
1.
Enable eth1 in the 'Edit Network Interfaces' menu.
2.
Click 'add a subnet', and configure it for network address 192.168.1.0 with netmask
255.255.255.0.
3.
Set the assigned address range to 192.168.1.101 - 192.168.1.200.
4.
Click 'Create' then edit the subnet just created and click 'Edit Client Options'.
5.
Set default routers to 192.168.1.1 and save.
6.
Restart the DHCP server or apply changes.
27.1.2.2. Single Network With Static IP Assignment
In this example the eth1 interface is provided with IP address 192.168.1.1/24.
Assign address 192.168.1.101 to a DHCP client with MAC 00:11:22:33:44:01.
Assign address 192.168.1.102 to a DHCP client with MAC 00:11:22:33:44:02.
Assign address 192.168.1.103 to a DHCP client with MAC 00:11:22:33:44:03.
The router serves as the default gateway.
1.
Enable eth1 in the 'Edit Network Interfaces' menu.
2.
Click 'add a subnet', and configure it for network address 192.168.1.0 with netmask
255.255.255.0.
3.
Click 'Create' then edit the subnet just created and click 'Edit Client Options'.
4.
Set default routers to 192.168.1.1 and save it.
5.
Click 'add a new host'.
6.
Set the hardware address to Ethernet 00:11:22:33:44:01 and the fixed IP to. 192.168.1.101.
Assign the client a hostname as well.
7.
Click 'Create'.
8.
Repeat steps 5) through 7) for the other hosts with the appropriate address, MAC and
hostname for each client.
9.
Restart the DHCP server or apply changes.
27.1.2.3. Single Network With Option82 Clients On One Switch
In this example the eth1 interface is provided with IP address 192.168.1.1/24
A a switch connected to eth1 and uses address 192.168.1.2/24.
The switch port 1 is connected to the router while its ports 2 through 8 provide DHCP relay support.
The switch has its DHCP relay server address set to router's address 192.168.1.1. The switch has all
ports in VLAN 1. The switch base MAC address is 00:0A:DC:11:22:00.
Assign a client at switch port 2 address 192.168.1.102.