RuggedCom RuggedRouter RX1100 - Manual (Page 242)

26. Configuring Layer 2 Tunnels
Revision 1.14.3 242 RX1000/RX1100™
26.2.7. Activity Trace Menu
Figure 26.10. Activity Trace Menu
This menu displays captured and decoded network activity on configured layer 2 tunnels.
The desired traffic sources, number of messages and length of time to capture are entered and the
Start Trace button is pressed. The menu will display up to the provided number of messages waiting
up to the specified number of seconds.
The Trace on protocols: selections feature a (all to short) list of protocols with unused entries greyed
out. The default is All Protocols.
The Message Decode field causes received/transmitted frame entries to include protocol specific
information. If the Hex Dump field is selected, the first 64 bytes of packet content is displayed.
The Packets field causes received/transmitted packet entries to be displayed.
The RTT Measurement field displays Beacon messages used for RTT measurement.
Note
Specifying large numbers of ports, entries and capture times can result in a great deal of
output. Specifying a large capture time may require the web page to wait that interval if activity
is infrequent.