RuggedCom RuggedRouter RX1100 - Manual (Page 65)

6. Configuring Ethernet Interfaces
Revision 1.14.3 65 RX1000/RX1100™
Figure 6.7. List PPPoE Interfaces
The PPPoE Interfaces table allows you to add a PPPoE interface on an Ethernet ports or change
PPPoE interface parameters of created interfaces. Only one PPPoE interface can be created on each
Ethernet port.
The Ethernet field shows all available Ethernet ports.
The Interface Name field shows created PPPoE interfaces and provides a link to edit the existing
configuration or create a new one.
The MTU, Use Peer DNS and Default Route fields are the configured information for PPPoE
interfaces.
The Status field shows the current PPPoE link status.
6.2.6. Edit PPPoE Interface
This menus allows you to edit a PPPoE interface.
Figure 6.8. Editing a PPPoE Interface
The PPPoE Username field determines the username to use when connecting to the PPPoE server
as specified by your provider.
The Password field determines the password provided to the PPPoE server.
The Default Route checkbox enables automatically setting a default route using this interface
whenever it connects. If this is your primary connection you probably want this option enabled.
The Use peer DNS checkbox enables automatically setting the DNS server entries that the PPPoE
server recommends. Enable this option unless you provide your own name servers.