RuggedCom RuggedRouter RX1100 - Manual (Page 287)

34. Maintaining The Router
Revision 1.14.3 287 RX1000/RX1100™
34.3.2.1. Configuring Industrial Defender Addresses
Figure 34.7. Industrial Defender Configuration – IP addresses saved
The Appliance Address is the IP address of the SEM unit. The IP address of the RuggedRouter
must also be specified as Source Address. Once this is done, save these addresses by clicking on
the Save Changes button.
34.3.2.2. Retrieving an Industrial Defender Key
Once the addresses are saved, a key can be retrieved from the SEM unit. To do so, enter the correct
password, as specified on the SEM unit, and then click Obtain a new key. In case of error, e.g. a
password mismatch, an error message to that effect will be shown at the top of the page.
Figure 34.8. Industrial Defender Configuration - key obtained