RuggedCom RuggedRouter RX1100 - Manual (Page 272)

32. Configuring IRIGB And IEEE1588
Revision 1.14.3 272 RX1000/RX1100™
This menu allow you to configure IRIGB parameters. The save button will save the changes of
configuration permanently.
The AM Port 1 (PTP1) Output field enables or disables the amplitude modulated output of this port.
The TTL Port 2 (PTP2) Output and TTL Port 3 (PTP3) Output fields sets the output formats of these
ports to PPS, PWM and OFF.
32.2.4. IEEE1588 Configuration
Figure 32.4. IEEE1588 Configuration Menu
This menu allows you to configure IEEE 1588 parameters.
The 1588 Working Mode field allows configures whether the router will be forced to 1588 slave mode
or determine its role by the BMC algorithm.
The Preferred Master Clock field configures the router to be preferred master clock.
The Subdomain Name field allows you to choose which domain you want the router to participate in.
There are four domains available, each mapped to a different multicast IP address.
The Sync Interval field configures the rate at which SYNC messages are issued.
The router NTP daemon uses GPS as a clock source when it is available and with IEE1588 when
GPS is not available.
The Treat NTP sync'd grandmaster as stratum field assigns the stratum number when grandmaster
clock synchronized with remote NTP server but not GPS.
The Treat Local Clock sync'd grandmaster as stratum field assigns the stratum number when
grandmaster clock synchronized with local clock but not NTP server or GPS.