RuggedCom RuggedRouter RX1100 - Manual (Page 248)

27. Configuring The DHCP server
Revision 1.14.3 248 RX1000/RX1100™
The switch port 2 is on vlan2 using subnet 192.168.2.0/24 and should assign addresses 192.168.2.101
to 192.168.2.200 and default gateway 192.168.2.1.
The switch port 3 is on vlan3 using subnet 192.168.3.0/24 and should assign addresses 192.168.3.101
to 192.168.3.200 and default gateway 192.168.3.1.
The switch port 4 is on vlan4 using subnet 192.168.4.0/24 and should assign addresses 192.168.4.101
to 192.168.4.200 and default gateway 192.168.4.1.
1. Enable eth1 in the 'Edit Network Interfaces' menu.
2. Add a new subnet, and configure it for network address 192.168.1.0 with netmask
255.255.255.0.
3. Save it.
4. Add a new shared network.
5. Name the shared network (for example "eth1") and select the subnet 192.168.1.0 to be
included in the shared network.
6. Save it.
7. Edit the shared network again.
8. Add a new subnet, and configure it for network address 192.168.2.0 with netmask
255.255.255.0
9. Save the new subnet and then save the shared network settings.
10. Edit the subnet just created and click 'Edit Client Options'.
11. Set default routers to 192.168.2.1 and save it.
12. Click 'add an address pool' to the subnet.
13. Set the address range to 192.168.2.101 to 192.168.2.200.
14. Click 'Create'.
15. Edit the pool by clicking on the link for the pool with address range 192.168.2.101 -
192.168.2.200.
16. Click 'add an option82 client'.
17. Give the client a unique alpha numeric name (for example subnet0102).
18. Set the remote id to the switch MAC address (00:0A:DC:11:22:00 in this case).
19. Set the circuit id to the switches circuit id identifier to the port (00:02:00:02 for VLAN 2 port
2 on a RuggedCom switch).
20. Click 'Create'.
21. Click 'Save'.
22. Repeat steps 8) through 20) for vlan3 through vlan4 changing the subnet, default routers, pool
address range and circuit id for each vlan.
23. Restart the DHCP server or apply changes.