Optibase MGW 2400 WMT - Manual (Page 26)

Chapter 2 • Getting Started
Connecting Peripherals - Encoders & Sources
To install an encoding module:
1. Make sure that MGW 2400 is switched off and disconnect
the power cable.
2. Remove the slot cover of the free slot in which you want to
install an encoding module.
3. Firmly push the encoding module into the slot until you
hear a click. This may require some force. A correctly
inserted module should be completely flush with the rest of
the unit, and must not protrude at all from the slot.
4. Screw the module to MGW 2400's rear panel.
5. Connect video and audio sources to the encoding module
as explained at page 18.
6. Switch MGW 2400 on again.
7. To add a new channel and set channel parameters, refer to
page 73.
Note
• Do not install or remove encoding modules while running MGW 2400.
This will cause damage to your MGW 2400 chassis and encoding
modules.
• Avoid touching inside free slots as this may cause electrical hazards
and damage your MGW 2400 unit.
• The Source LED only turns green if a video source is connected to the
encoding module. If you only connect an audio source, the Source LED
remains off.
16