Optibase MGW 2400 WMT - Manual (Page 32)

Chapter 2 • Initial Configuration
DHCP enabled Networks
DHCP automatically provides TCP/IP settings for the NIC
connected to the respective DHCP enabled network.
In certain cases, you might want to assign unique IP addresses.
To change IP addresses, refer to your local network
administrator. For instructions on changing TCP/IP settings,
refer to page 34.
By default, NIC A is DHCP enabled and NIC B is DHCP
disabled.
To communicate with MGW 2400, you have to connect the
Configuration PC's COM1 port to MGW 2400’s RS-232 port.
The Configuration PC must have HyperTerminal installed. For
further information regarding the Configuration PC, refer to
page 2. To enable the Configuration PC to communicate with
MGW 2400, you have to first set the correct parameters for
HyperTerminal’s COM properties.
22