Optibase MGW 2400 WMT - Manual (Page 61)

Chapter 3 • Installing Software
To edit the default IP address at a later stage:
1. Make sure that you close the MGW 2400 EMS.
2. Browse the MGW 2400 EMS folders for EMSConfig.ini
and create a backup. Save the backup in a different folder
on your PC.
3. Open EMSConfi.ini; the first line reads for example
ems2400.snmp.deviceIP 172.16.100.137.
4. Change the registered IP address to the desired IP address.
5. Save and close EMSConfig.ini; the MGW 2400 EMS
displays the new IP address once the MGW 2400 EMS
Logon window appears.
Note
• Make sure that only one NIC is enabled on the Management PC,
otherwise the MGW 2400 EMS cannot communicate properly with MGW
2400.
• To install a new version of MGW 2400 EMS at a later stage, first
uninstall the current version of MGW 2400 EMS.
• If the available disk space is insufficient, installing MGW 2400 EMS will
fail.
• If you want to uninstall the MGW 2400 EMS after you edited
EMSConfig.ini, you will have to manually delete the MGW 2400 folder.
51