Optibase MGW 2400 WMT - Manual (Page 27)

Chapter 2 • Getting Started
To remove an encoding module:
1. Make sure that MGW 2400 is switched off and disconnect
the power cable.
2. Disconnect video and audio source cables.
3. Loosen the screws on the left and right side of the rear
panel and carefully pull the encoding module out of the
slot.
4. Screw the slot cover to MGW 2400’s rear panel.
5. Switch MGW 2400 on again.
Note
• Do not install or remove encoding modules while running MGW 2400.
This will cause damage to your MGW 2400 chassis and encoding
modules.
• Avoid touching inside free slots as this may cause electrical hazards.
Touching inside free slots may also damage your MGW 2400 unit.
17