Optibase MGW 2400 WMT - Manual (Page 38)

Chapter 2 • Initial Configuration
MGW 2400’s Network Settings
MGW 2400 comes with two network interface cards. To
increase performance, you can assign one network to manage
and configure MGW 2400, and the other one to transmit. MGW
2400 lets you change network settings for both network
interface cards.
Selecting the Network Mode
By default, both NICs are set to 100Mbps Full Duplex. If
relevant, you have to set the network mode for each NIC
separately.
To select the network mode:
1. Log on to MGW 2400’s Configuration Utility as
Administrator; the Main menu appears.
2. Press 2 (Change Network Settings); the Network menu
appears as illustrated in Figure 12.
3. To choose the network mode for NIC A, press 3; to choose
the network mode for NIC B, press 4; the Network Mode
Settings menu appears as illustrated in Figure 13.
4. Consult your network administrator before selecting one of
the displayed modes.
5. Press the respective number key to select the desired
network mode and follow the on-screen instructions; the
respective network mode is defined.
Note
• You must set the network mode for each NIC separately.
• Transmission to external WMS servers requires 100Mbps Full Duplex.
28