Optibase MGW 2400 WMT - Manual (Page 45)

Chapter 2 • Initial Configuration
To define or change TCP/IP settings:
1. Enter the new IP address and Subnet mask for the relevant
NIC and press Enter. Make sure that each NIC’s IP
address belongs to a different subnet.
2. To make MGW 2400 accessible from outside your local
network for the relevant NIC, define the Default Gateway
server's IP address and press Enter.
3. If you do not want MGW 2400 to be accessible from
outside your local network via the relevant NIC, type 0 for
Default Gateway and press Enter; the new parameters for
the relevant NIC are defined and MGW 2400 returns to the
Network menu.
4. To register MGW 2400 in the WINS data base, enter the
WINS server's IP address and press Enter. If you do not
want to define a WINS server or no WINS server exists in
your network, type 0 and press Enter.
Make sure that you do not press Enter without typing any
value as this could cause MGW 2400 to fail.
Figure 15: Define TCP/IP Settings for NIC A
35