Optibase MGW 2400 WMT - Manual (Page 44)

Chapter 2 • Initial Configuration
If DHCP is disabled – TCP/IP Settings
If the relevant NIC or network segments are not DHCP enabled,
you have to edit TCP/IP settings manually when logging on for
the first time. If desired, you may disable DHCP and set or
change TCP/IP settings manually.
You disable DHCP and/or edit TCP/IP settings as explained
below.
To choose a NIC and disable DHCP:
1. Log on to MGW 2400’s Configuration Utility as
Administrator; the Main menu appears.
2. Press 2 (Change Network Settings); the Network menu
appears.
3. To edit TCP/IP settings for NIC A, press 1, or for NIC B,
press 2; DHCP options appear for the NIC you chose.
4. Type 2 (Disable DHCP and set TCP/IP parameters
manually); DHCP is disabled and TCP/IP options appear
as illustrated in Figure 15.
5. To define or change the chosen NIC's TCP/IP settings,
refer to the next page.
34