Optibase MGW 2400 WMT - Manual (Page 97)

Chapter 3 • Editing Channel Parameters
Parameters Settings Comments
Output NIC IP address of the NIC via which
content transmits. No external WMS
server.
Choose the MGW
2400 NIC that you use
for transmission.
External WMS
server.
Type the IP address
of the external WMS
server's NIC that you
use for transmission.
Target IP
address Multicast IP addresses
224.1.1.1 - 239.255.255.255 Enter an IP address
within the listed range.
Make sure that the
relevant receivers are
set to the same
Multicast IP address.
Other Multicast IP
addresses are
reserved for certain
tasks or devices and
can cause network
conflicts if used for
different purposes.
Port You may use ports between 1024
and 20000. Do not use ports
between 7008 and 7013. Make sure you set a
unique port for each
target you add.
UDP Block Size 1024 - 20000
(default is 0 for Automatic)
We recommend
setting the UDP Block
Size value to 0 for
Automatic.
The UDP Block Size
depends on the video
and audio bit-rates.
The values set by
MGW 2400 can be
found at page 113.
87