Optibase MGW 2400 WMT - Manual (Page 31)

Chapter 2 • Initial Configuration
To set communication parameters in HyperTerminal:
1. Open HyperTerminal and click Properties in
HyperTerminal’s toolbar. The Properties screen appears.
2. From the Connect using list, choose COM1 to which you
will connect MGW 2400 and click Configure. The COM
Properties screen appears.
Figure 9: HyperTerminal’s COM Properties Screen
3. Enter the parameters into the respective fields as shown in
Figure 9.
4. Click OK; HyperTerminal is now ready to communicate
with MGW 2400.
21