Optibase MGW 2400 WMT - Manual (Page 42)

Chapter 2 • Initial Configuration
6. To return to the Main menu, press 0 (Main Menu); the
Main menu appears.
7. To log off MGW 2400, press 0 (Quit). If you added or
removed one or more DNS IP addresses, you will be asked
whether you want to restart now or later.
8. To restart now, press Y; the Logon prompt appears and
MGW 2400 reboots, which may take several minutes. The
booting is completed when you hear a beep and the Power
LED turns green.
9. To log on again, type the username and password for
Administrator; the Main menu appears.
10. To restart later, press N; the Logon prompt appears. You
will have to restart MGW 2400 at a later stage.
11. If you don’t want to log on again, terminate the connection.
Note
• You should set at least one DNS IP address.
• We recommend that you make a note of all DNS IP addresses you set.
You can use the table provided at page 103 for your convenience.
• It is necessary to restart MGW 2400 in order for changes to take effect.
We highly recommend you restart the system after exiting the
configuration utility, as prompted.
32