Optibase MGW 2400 WMT - Manual (Page 58)

Chapter 3 • Installing Software
Installing Software
This section instructs you on configuring your Management PC
and installing the MGW 2400 EMS.
System Requirements
• Pentium-III PC 500 MHz or higher with one 10/100BT
network interface card (NIC) installed.
If your PC has more than one NIC installed, use the
Add/Remove Hardware wizard to disable the additional
NICs.
• MGW 2400 currently supports the following operating
systems:
• Windows 2000 Professional with Service Pack 4 or
higher.
• Windows XP Professional with Service Pack 1 or
higher.
• 128 MB RAM or more, depending on the number of MGW
2400 units you manage from the relevant PC.
• 100 MB virtual memory or higher. For instructions on
setting virtual memory on your PC, refer to the relevant
Microsoft Windows documentation.
• 200 MB free disk space or more.
• CD-ROM drive (16× or faster)
Configuring the Management PC for the Network
• Go to My Network Places and then to Local Area
Connection.
• Refer to the relevant Microsoft Windows documentation for
further instructions.
48