Optibase MGW 2400 WMT - Manual (Page 46)

Chapter 2 • Initial Configuration
5. Make a note of your settings of your TCP/IP settings upon
changing. You can use the table provided at page 103 for
your convenience
6. To define or change TCP/IP settings for the second NIC,
follow the instructions on the previous page again.
7. To return to the Main menu, press 0 (Main Menu).
8. To log off MGW 2400, press 0 (Quit); you will be asked
whether you want to restart now or later.
9. To restart MGW 2400 now, press Y; the Logon prompt
appears and MGW 2400 reboots, which may take several
minutes. The booting is completed when you hear a beep
and the Power LED turns green.
10. To log on again, type the username and password for
Administrator; the Main menu appears.
11. To restart MGW 2400 later, press N; the Logon prompt
appears. You will have to restart MGW 2400 manually at a
later stage.
12. If you don’t want to log on again, terminate the connection.
MGW 2400 is now ready to start operating. For instructions on
operating MGW 2400, refer to chapter 3.
Note
It is necessary to restart MGW 2400 in order for changes to take effect. We
highly recommend you restart the system after exiting the configuration
utility, as prompted.
36