ACU-RITE MILLPWR 3 Axes - Manual (Page 115)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-19
• Enter the Z-axis feed rate.
• Select a tool offset by pressing the appropriate softkey.
• Enter the table’s feed rate.
• If you wish to program a 2 ND Corner and/or a tilt angle or
would like to program a finish cut, press the MORE softkey.
2 ND Corner
Enter the X- and Y-axes coordinates for the 2 ND Corner.
(The 2 ND Corner must be located diagonally across from
the 1 ST Corner.)
Tilt Angle
Enter the tilt angle.
Finish
Enter a stepover percentage (how much you want your tool to overlap on each
pass).
• Press the USE key.
Note: If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).