ACU-RITE MILLPWR 3 Axes - Manual (Page 167)

CALCULATOR
MILLPWR ®
Operation Manual
The kinds of calculations that GeoCalc performs depends on the items you select and
whether you’re trying to find a point, line, or arc. The table below lists all of the points,
lines and arcs that can be found by GeoCalc.
6-5
2 Points
1 Point
1 Line
1 Point
1 Arc
1 Line
2 Lines
1 Line
1 Arc
1 Arc
2 Arcs
1 Arc
Midpoint between the
given points.
Point on the given
line which, with the
given point, would
form a line perpendic-
ular to the given line.
Points which, with
the given point,
would form lines tan-
gent to the given arc
and the shortest line
from the given point
to the given arc.
End points of the
given line.
Intersection point of
the given lines.
Points where given
line intersects given
arc.
Center point, end
points.
Intersection points.
Line between the given
points.
Lines through the given
point, one parallel and one
perpendicular to the given
line.
Lines through the given
point tangent to the given
arc, and the shortest line
through the given point to
the given arc.
Given a distance, lines paral-
lel to the given line; lines
perpendicular to the given
line through its end points.
Line that bisects the angle
formed where the given lines
intersect; line perpendicular
to the bisector.
Lines perpendicular to the
given line and tangent to the
given arc; shortest line to the
given arc which is perpen-
dicular to the given line.
Given an angle, all lines tangent to
and through the center point of the
arc; lines from the end points to the
center point.
Lines tangent to arcs; short-
est line between arcs.
Given a radius, all arcs through the given
points.
The Auto Radius softkey gives you two
arcs, each tangent to both points with the
midpoint as its center point.
Given a radius, all arcs through the given
point and tangent to a given line.
The Auto Radius softkey gives you two
arcs, each tangent to the given line with
the given point as its center point.
Given a radius, all arcs through the given
point and tangent to the given arc.
The Auto Radius softkey gives you all
arcs tangent to the given arc with the
given point as its center point.
Given a radius, all arcs tangent to both
given lines.
Given a radius, all arcs tangent to the
given line and the given arc.
Given a radius, all arcs tangent to both
arcs.
Items Find Point Find Arc Find Line