ACU-RITE MILLPWR 3 Axes - Manual (Page 123)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-27
• For “Direction,” press the CW softkey for clockwise or the
CCW softkey for a counter-clockwise direction.
• Enter the table’s feed rate.
• If you would like to program a finish cut, press the MORE
softkey.
Enter the amount of material to be removed during the finish
cut.
Enter the feed rate for the finish cut.
Select the finish cut's direction. Press the CW softkey for clockwise or the CCW softkey
for a counter-clockwise direction.
Enter a stepover percentage (how much you want your tool to overlap on each pass).
• Press the USE key.
Note: If your tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).