ACU-RITE MILLPWR 3 Axes - Manual (Page 130)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-34
2 ND Corner
Enter the X- and Y-axes coordinates for the 2 ND Corner (located diagonally from
the 1 ST corner).
Hole Spacing
Specify the spacing between holes along the X- and Y-axes.
Tilt Angle
Enter a tilt angle, if needed.
• Press the USE key.
Note: If the tool size and type listed in the "Tool" field are incorrect, change the
tool settings before running your program (refer to Programming a Tool Step).