ACU-RITE MILLPWR 3 Axes - Manual (Page 27)

DRO
MILLPWR ®
Operation Manual 2-4
DRO Functions
The digital readout (DRO) display shows you the current tool position. While
operating in the DRO mode, you can use several functions, such as skew and
datum, to set up your job. You can also use this as a standard DRO when you use
your machine manually.
Move Table
The move table feature lets you move the table rapidly (or at an established feed rate)
using the arrow keys.
• Press the MOVE TABLE softkey to turn the servo motors on. Press
it again to turn them off.
• Enter the desired feed rate or skip this step to move at a rapid
feed rate.
• If you want the arrow keys to move the table in increments, press
the
0.001 , 0.01 or 0.1 softkey. (A different set of softkeys will
appear if you are measuring in millimeters.)
• Move the table. You can move the X-, Y- and Z-axes simultaneously by pressing
two arrow keys and
Z UP or Z DOWN softkeys at the same time.
• Press the FEED+ and FEED- keys to adjust your feed rate.
It’s a good idea
to fold in the
handles before
moving the
table.