ACU-RITE MILLPWR 3 Axes - Manual (Page 239)

TROUBLESHOOTING GUIDE
MILLPWR ®
Operation Manual 9-14
No response from PC
(cont'd)
Time-out error
The selected COM port
is disabled.
Loose serial cable
Change the PC's COM
port setting and connect
the serial cable into the
appropriate port;
-OR-
Exit the remote storage
program on your PC, then
refer to your PC’s opera-
tion manual for instruc-
tions on how to enable a
COM port.
Check that the serial cable
is properly connected to
MILLPWR and to your PC.
Your PC’s COM port
setting is different from
the COM port that your
serial cable is connected
to. If the COM port setting
(1 or 2) on the PC screen
does not correlate with the
COM port that the serial
cable is connected to:
Change your PC’s COM
port setting;
-OR-
Disconnect the cable from
the COM port that it is
connected to and connect it
to a different COM port.
Symptom
Recommended
Corrective Action
Probable Cause