ACU-RITE MILLPWR 3 Axes - Manual (Page 64)

PROGRAMMING
MILLPWR ®
Operation Manual 3-28
From your PC:
• Save then clear, any open programs.
• From the PGM screen, press the PROGRAM FUNCTION softkey, then press the
DIRECTORY softkey.
• Press the SELECT DIRECTORY softkey.
• Press the REMOTE STORAGE softkey. (If the REMOTE STORAGE softkey does not
appear, then it is likely the MILLPWR and your PC have not been set up. Refer to
Remote Storage and/or Installation Setup.) Select the directory you wish to use.
• Press the USE softkey.
• Press the LOAD softkey.
• Press the FORMAT key until MPT is displayed.
• Select the directory that contains your program (refer to Selecting a Directory).
Translating a DXF file:
• Save, then clear, any running programs.
• Locate the directory containing your DXF file (refer to Selecting a Directory).
• From the PGM screen, press the PROGRAM FUNCTIONS soft-
key, then press the LOAD softkey.
• Select the storage location of your DXF file.
(on a 3
1 /
2
" floppy disk or on a PC):
If your DXF file is stored on a 3 1 /
2
" floppy disk:
• Insert the floppy disk containing the DXF file you want to load into the floppy
disk drive (located in the lower right-hand corner of the operator console).
• Press the USE FLOPPY softkey.
• Press the FORMAT softkey until DXF is displayed. The screen will display all of the
DXF files stored in the directory you’ve chosen.
• Using the arrow keys, highlight the DXF file you want to translate.