ACU-RITE MILLPWR 3 Axes - Manual (Page 139)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-43
To program a contour:
• From the PGM screen, highlight the step below the
last step in the continuous contour.
• Press the MORE STEPS softkey.
• Press the CONTOUR softkey.
• You’ll notice that “First” and “Last” in the “Step
Range” field will be filled in for you.
• If you wish to program an approach, press the
STRAIGHT or ARC softkey as your approach
type. Otherwise, press the NONE softkey.
Enter how far from the part you want the approach to
begin.
• To program a departure, press the STRAIGHT or ARC softkey as
your departure type. Otherwise, press the NONE softkey.
Enter how far from the part you want your tool to travel.
• If you would like to program a finish cut, enter the amount of material to be
removed during the finish cut.
Enter the feed rate.
Using the softkeys, select the finish pass direction ( FORWARD or REVERSE ).
• Press the USE key.