GE Industrial Solutions AF-600 FP High Power (460V_575V 150HP and above) - Manual (Page 15)

Display lines:
a. Status line: Status messages displaying icons and graphics.
b. Line 1-2: Operator data lines displaying data and variables defined
or chosen by the user. By pressing the [Status] key, up to one extra
line can be added.
c. Status line: Status messages displaying text.
The display is divided into three sections:
Top section (a) shows the status when in status mode or up to two variables when not in status mode and in the case of Alarm/Warning.
The number of the Active Set-up (selected as the Active Set-up in par. K-10 Active Set-up) is shown. When programming in another Set-up than the Active Set-up,
the number of the Set-up being programmed appears to the right in brackets.
The Middle section (b) shows up to 5 variables with related unit, regardless of status. In case of alarm/warning, the warning is shown instead of the variables.
It is possible to toggle between three status readout displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The values/measurements to be displayed can be defined via par.
K-20, K-21, K-22, K-23 and K-24
Each value/measurement readout parameter selected in par. K-20 Display Line 1.1 Small to par. K-24 Display Line 3 Large has its own scale and number of digits
after a possible decimal point. Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
AF-650 GP and AF-600 FP High Power Service Manual
14
2