GE Industrial Solutions AF-600 FP High Power (460V_575V 150HP and above) - Manual (Page 20)

2.3 Status Messages
Status messages appear in the bottom of the display - see the example below.
The left part of the status line indicates the active operation model of the frequency converter.
The centre part of the status line indicates the references site.
The last part of the status line gives the operation status, e.g. Running, Stop or Stand by.
Other status messages may appear related to the software version and frequency converter type.
Operation Mode
[Off] The drive does not react to any control signal until [Auto] or [Hand] on the Keypad are pressed.
[Auto] The drive is controlled via the control terminals and/or the serial communication.
[Hand] Only stop commands, alarm resets (Reset), reversing, DC brake, and set-up selection signals can be applied to the control terminals.
For further information about the LCD display, please see the chapter How to program in the Programming Guide.
AF-650 GP and AF-600 FP High Power Service Manual
19
2