GE Industrial Solutions AF-600 FP High Power (460V_575V 150HP and above) - Manual (Page 24)

A serious alarm occurred. It is possible, provided the cause of the alarm was cleared, to reset the alarm after the mains have been switched off and on again. This
can be done via a reset signal ([Reset] on the Keypad, a control terminal or serial communication).
Unit/Drive not ready
PROFIDrive profile was selected in par. O-10 Control Word Profile. A control word is sent to the drive via serial communication with Off 1, Off 2 and Off 3 active.
Start inhibit is active. To enable start, see operation status Start inhibit.
2.4 Service Functions
Service information for the frequency converter can be shown on display lines
3 and 4. Included in the data are counters that tabulate operating hours,
power ups and trips; fault logs that store frequency converter status values
present at the 20 most recent events that stopped the frequency converter;
and frequency converter nameplate data. The service information is ac-
cessed by displaying items in the frequency converter's ID-## parameter
group.
Parameter settings are displayed by pressing the [MAIN MENU] key on the
Keypad.
Use the arrow keys [
▲
], [
▼
], [ ►] and [◄] on the Keypad to scroll through pa-
rameters.
See the Drives Series Operating Instructions for detailed information on accessing and displaying parameters and for descriptions and procedures for service
information available in the ID-## parameter group.
AF-650 GP and AF-600 FP High Power Service Manual
23
2