Luminex xPONENT 4.0 SP1 - Manual (Page 74)

Luminex xPONENT 4.0 Software Manual
62
• Units - The unit of measurement you specified in the Unit box. Click this box to type a
value for the analyte.
• Count - The total desired bead count for an analyte. Click this box to type a value. The
system continues analyzing until each bead set has met the minimum events as
determined in the Count box above. If you select the Stop after total bead count
reaches: check box and type a total count in the corresponding box, this column does
not appear.
• Region - Refers to the specific analyte selected. It is a number from 1 to 500.
Group. If you have selected Allele Call from the Analysis Type in the Settings tab, this
button displays. Click Group to group 2, 3, or 4 analytes for the group. Multiple groups can
be made.
Cancel. Click to return to the Protocols tab.
Back. Click to return to the Settings tab.
Next. Click to go to the next tab.
Plate Layout Tab
Use this tab to define commands that apply to one or more wells. You can define
commands.
FIGURE 42. Plate Layout Tab
This tab contains the following:
Plate Image. This is a representation of the plate. Each well appears as a circle on the
grid. Well commands appear in the appropriate circles as you assign them to wells on the
plate. If using a 384 well plate, the Plate Navigation section in the lower right part of the
window is a bounding box that can be used to display all the wells in the main plate image
at the upper left portion of the window. Click and drag the box to display different portions
of the plate.