Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 121)

Getting Started Manual
922157-00 Rev A 113
Setting Up Channels
1. Touch Vertical → Channelx Setup... from the menu bar.
2. Touch inside the Trace On checkbox to display the trace.
3. On pertinent model oscilloscopes, under Selected Input, touch the
Input A (Upper) button or Input B (Lower) button. Otherwise, no
Selected Input buttons are provided.
4. Turn the V ERTICAL G AIN front panel knob for the selected channel.
OR
Touch inside the Volts/Div field and enter a value. Click the keypad
button to enter a value using the pop-up keypad, or use the
up/down arrows.
The set voltage is shown on the trace descriptor label and in the
Volts/Div field in the dialog.
5. Turn the V
ERTICAL
O
FFSET
adjust front panel knob directly above the
channel button whose waveform you want to move vertically. Or
you can touch inside the Offset field and type in a value on the pop-
up keypad. To set the vertical offset to zero, touch the Zero button
directly below the Offset field.
6. Touch inside the Coupling control and select a coupling mode from
the pop-up menu.
7. Touch inside the Bandwidth control and provide a Bandwidth Limit
value using your preferred input control method. Additional
information on using the touch screen controls can be found in the
Dialog Area (on page 87).
8. Touch inside the Probe Atten. data entry control if you want to set
the attenuation manually, and provide a value using your preferred
input control method. Additional information on using the touch
screen controls can be found in the Dialog Area (on page 87).