Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 166)

LabMaster 9 Zi-A
158 922157-00 Rev A
Cursor Setup
After using one of the above methods to access cursors, the Cursors dialog
is displayed.
Cursor Types

Horizontal Abs - Provides a single, dashed, vertical line and cross-
hair marking for the specific cursor location. None of the Show
controls are provided; however, the Position 1 control is enabled on
the right of the dialog.

Horizontal Rel - Provides two, dashed, vertical lines and cross-hair
markings for the specific cursor locations. Since there are two
cursors involved, controls for Show along with Track, and Position 1
and 2 are available on the dialog.

Vertical Abs - Provides a single, dashed, horizontal line and cross-
hair marking for the specific cursor location. None of the Show
controls are provided; however, the Position 1 control is enabled on
the right of the dialog.

Vertical Rel - Provides a single, dashed, horizontal line and cross-hair
marking for the specific cursor location. None of the Show controls
are provided; however, the Position 1 control is enabled on the right
of the dialog.

Both Rel – Provides both Horizontal Rel and Vertical Rel cursor lines.
Show (for Relative Cursor Types)
Show controls (Absolute, Delta, Abs+Delta, and Slope) become available
on the dialog when Relative Cursors (Horizontal or Vertical Rel cursor
types) are chosen.
For Horizontal and Vertical Rel cursor types, you can also specify Position 1
and 2 time values for your cursor locations. You also have the option to
mark the Track checkbox which allows you to move your Position 1 cursor
(using the touch-screen display or front panel control) and have both