Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 88)

LabMaster 9 Zi-A
80 922157-00 Rev A

Stop - Press to prevent the oscilloscope from triggering on a signal. If
you boot up the instrument with the trigger in Stop mode, the
message "no trace available" is shown.

Trigger Setup - Press to open the Trigger Setup... dialog.
Corresponds with screen menu selection: Trigger → Trigger Setup....
Quick Access Processing Functions
The Processing section allows you to suspend your system from processing
data. You can stop data processing, make adjustments, and then resume
data processing with the touch of two on-screen buttons.
Touching the Stop button shows the Processing Paused... pop-up.
Touch the Resume button to continue processing data.
At times, an Undo button is made available to the right of the Quick Access
Toolbar on the Menu Bar.
Quick Access Undo Function
The Undo button is labeled with the most recent action (Autoset being the
most recent action in the screen-shot of the Quick Access Toolbar at the
beginning of this topic). This helps make you aware of the specific function
prior to reversal.