Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 214)

LabMaster 9 Zi-A
206 922157-00 Rev A
Recalling Waveforms
NOTE: Only .trc files saved in binary format can be recalled into the oscilloscope.
Access the Recall Waveform dialog by either selecting File → Recall
Waveform from the menu bar or clicking the Recall Waveform button on
the main Save/Recall dialog.
1. Select either Memory or File by touching either respective button on
the Recall From portion of the dialog.
NOTE: When Memory is selected, only Source, Destination, and Show on
recall controls are shown on the Recall Waveform dialog. When File is
selected, many more controls are available. Regardless, the controls are
used as explained in the following steps.
2. If recalling from Memory, touch inside the Source control and select
a source stored in non-volatile RAM (M1–M4) from the Select
Source pop-up.
3. Touch inside the Destination control and select a location for
storage (memory or file) from M1 to M4.
4. Show on Recall - Mark this checkbox to have the memory trace
shown on the grid display after recalling the waveform.
5. When saving a File, touch inside the Show only files control and
select an area to limit the search (channels, math functions, or
memory).
6. Touch inside the Recall files from directory data entry control and
provide the path. You can also touch the Browse button and
navigate to the file. Touch inside the Next file will be recalled from
data entry control and provide the path or, touch the Browse
button to navigate to the file.